A Full-Bridge Bidirectional DC-DC Converter with Fuzzy Logic Voltage Control for Battery Energy Storage System
Renewable energy sources require an energy storage system because its are fluctuating and electricity producing at certain times, even sometimes not in accordance with the needs of the load. To maintain continuity of electricity, smart battery energy storage system is needed. Therefore, this paper of a full-bridge bidirectional DC-DC Converter (FB-BDC) with Fuzzy Logic Control (FLC) is designed and implemented for battery energy storage application. The FLC has error and delta error of voltage level as input and duty cycle of FB-BDC as output. The FB-BDC is controlled by a microcontroller ARM Cortex-M4F STM32F407VG for voltage mode control. The FB-BDC topology is selected becuase battery storage system needed isolated and need high voltage ratio both for step-up and step-down. The main purpose of FB-BDC to perform bidirectional energy transfer both of DC-Bus and battery. Moreover, FB-BDC controls the DC-Bus voltage according to referenced value. The power flow and voltage on DC-Bus is controlled by FLC with voltage mode control. The experiment result shows the ability of FLCÂ voltage mode control to control FB-BDC on regulate charging voltage with an error 1% and sharing voltage 1.5% form referenced value.
Trowler, Derik. Whitaker, Bret. Bi-Directional Inverter and Energy Storage System. Texas Instruments Analog Design Contest. May 2008.
Kusdiana, Dadan., Real conditions of energy in Indonesia and renewable alternative energy sources, Directorate General of Energy and Energy and Mineral Resources Utilization, Bogor, 3 December 2008.
Saleh, Darwin Zahedy., The electricity development master plan for 2010 to 2014, Ministry of Energy and Mineral Resources of the Republic of Indonesia. Jakarta, December 2009.
S. Inoue and H. Akagi. A bidirectional isolated dc/dc converter as a core circuit of the next generation medium voltagepower conversion system, IEEE Trans. Power Electron. 22(2), 535â€“542 (2007).
Kuei-Hsiang Chao, Ming-Chang Tseng, Chun-Hao Huang, Yang-Guang Liu, and Liang-Chiao Huang, Design and Implementation of a Bidirectional DC-DC Converter for Stand-Alone Photovoltaic Systems, International Journal of Computer, Consumer and Control (IJ3C), Vol. 2, No.3, 2013.
Alireza Bakhshai. Bidirectional DC â€“ DC Converters for Energy Storage Systems, Energy Storage in the Emerging Era of SmartGrids, Prof. Rosario Carbone (Ed.), ISBN: 978-953-307-269-2, InTech, September 2011.
Nadia Mei Lin Tan, Takahiro Abe, Hirofumi Akagi, Design and Performance of a Bidirectional Isolated DC-DC Converter for a Battrey Energy Storage system, IEEE Transactions on Power Electronic vol.27 No3, March 2012.
N. Mohan, T.M. Undeland, W.P. Robbins, Power Electronics: Converters, Applications, and Design, 2nd ed., 1995, Wiley, New York, USA.
D. W. Hart, Introduction to power electronics, Prentice, Prentice-Hall of USA, New York, 2003.
D.Xu, C. Zhao, and H. Fan. A PWM Plus Phase- Shift Control Bidirectional DC-DC Converter, IEEE Trans. Power Electron., Vol.19, pp.666-675, May 2014
Mofakkharul Islam, Masuma Masrin, Abu Bashar Sarkar, An Isolated Bidirectional DC-DC Converter for Enenrgy Storage System, PCIM Europe, May, Nuremberg Germany, 2017.
Rugaju, M. Janse van Rensburg, J.F dan Pienar H.C.vZ, Full Bridge DC-DC Converter as Input Stage for Fuel Cell Inverter System,Vaal University of Technologi,1900.
Dehnavi, sayed M.D, Gokhan, Thomsen Ole Cornelius, Andersen Michael, Moller Lars, Isolated Bidirectional DC-DC Converter for SuperCapasitor Application, ICREPQâ€™11 International Conference on Renewable Energies and Powe Quality, Technical Universty of Denmark, 2011.
Muhammed Shaveel T M, Vinod John, Isolated Bidirectional DC-DC Power Supply for Charging and Discharging Battery, Indian Institue of Science, Bangalore India, 2013.
Ganji Sai Kumar, G. Ramudu, D. Vijay Arun, Analysis and Implementation of bidirectional DC to DC Converter by using Fuzzy logic Controller, The International Journal of Engineering and Science (IJES), Volume 3, Issue 6, Pages 22-39, 2014.
A. Srilatha, Fatimaazraand R. Venkatezwarlu, Fuzzy logic controlled bidirectional dc-dc converter applied to dc drive, International Journal of Electrical and Electronics Engineering Research (IJEEER), Vol. 4, Issue 6, 25-36. Dec 2014.
A. Uma Siva Jyothi, D S Phani Gopal and G. Ramu, Bi-Directional Dc-Dc converter Drive with PI and Fuzzy Logic Controller, International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering, Vol. 2, Issue 11, November 2013.
Prasetyono, E., Anggriawan, D.O., Firmansyah, A.Z., Windarko, N.A., â€œA modified MPPT Algorithm Using Incremental Conductance for Constant Power Generation of Photovoltaic Systemsâ€, International Electronics Symposium on Engineering Technology and Application, 2017
Wahjono, E., Anggriawan, D.O., Sunarno, E., Nugraha, S. D., Tjahjono, A., â€œMaximum Power Point Tracking of Photovoltaic Module for Battery Charging Based on Modified Particle Swarm Optimizationâ€, International Review on Modelling and Simulations, Vol. 10, No. 1, 2017
Tjahjono, A., Qudsi, O.A., Windarko, N.A., Anggriawan, D.O., Priyadi, A., Purnomo, M.H., â€œPhotovoltaic Module and Maximum Power Point Tracking Modelling Using Adaptive Neuro-Fuzzy Inference Systemâ€, IEEE conference of Makassar International Conference on Electrical Engineering and Informatics (MICEEI), Nov., 2014
Deepika M, Marimuthu M, Paranthagan B. Comparative analysis of proportional integral derivative controller and Fuzzy Logic controller on interleaved soft switching boost converter. International Conference on Circuit, Power and Computing Technologies (IEEE) 2014:307â€“312.
Copyright (c) 2019 EMITTER International Journal of Engineering Technology
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
The copyright to this article is transferred to Politeknik Elektronika Negeri Surabaya(PENS) if and when the article is accepted for publication. The undersigned hereby transfers any and all rights in and to the paper including without limitation all copyrights to PENS. The undersigned hereby represents and warrants that the paper is original and that he/she is the author of the paper, except for material that is clearly identified as to its original source, with permission notices from the copyright owners where required. The undersigned represents that he/she has the power and authority to make and execute this assignment. The copyright transfer form can be downloaded here .
The corresponding author signs for and accepts responsibility for releasing this material on behalf of any and all co-authors. This agreement is to be signed by at least one of the authors who have obtained the assent of the co-author(s) where applicable. After submission of this agreement signed by the corresponding author, changes of authorship or in the order of the authors listed will not be accepted.
Retained Rights/Terms and Conditions
- Authors retain all proprietary rights in any process, procedure, or article of manufacture described in the Work.
- Authors may reproduce or authorize others to reproduce the work or derivative works for the author’s personal use or company use, provided that the source and the copyright notice of Politeknik Elektronika Negeri Surabaya (PENS) publisher are indicated.
- Authors are allowed to use and reuse their articles under the same CC-BY-NC-SA license as third parties.
- Third-parties are allowed to share and adapt the publication work for all non-commercial purposes and if they remix, transform, or build upon the material, they must distribute under the same license as the original.
To avoid plagiarism activities, the manuscript will be checked twice by the Editorial Board of the EMITTER International Journal of Engineering Technology (EMITTER Journal) using iThenticate Plagiarism Checker and the CrossCheck plagiarism screening service. The similarity score of a manuscript has should be less than 25%. The manuscript that plagiarizes another author’s work or author's own will be rejected by EMITTER Journal.
Authors are expected to comply with EMITTER Journal's plagiarism rules by downloading and signing the plagiarism declaration form here and resubmitting the form, along with the copyright transfer form via online submission.